Gate Service · Oakville

Automatic Gate Repair in Oakville, ON

When an automatic gate stops mid-swing, refuses to open, or slams instead of easing shut, it is usually the operator, the sensors, or the alignment between them, rarely the whole system. We diagnose the actual fault on automatic gates across Oakville and get you back to a gate that opens on the first press.

Click Here to Call (647) 930-4513 Now Book a visit

What this covers

Operator and control-board diagnosis and replacement
Photo-eye and safety-edge (entrapment sensor) faults
Limit-switch and travel-limit re-calibration
Circuit boards, capacitors, transformers and wiring
Battery back-up and low-voltage power problems
Force and speed adjustment so the gate reverses on contact

Safe & to standard. We set automated gates up to ANSI/CAN/UL 325 and ASTM F2200, so the gate reverses on contact and its entrapment sensors work — not just that it moves.

Signs you need this repair

Gate opens but will not close (or reverses immediately)
Operator hums or clicks but the gate does not move
Intermittent operation in cold or wet weather
Gate no longer stops or reverses on an obstruction

Brands we work with

LiftMasterChamberlainDoorKing (DKS)FAACNice / ApolloVikingBFTCAMERamsetGTO / Mighty MuleHySecurityElite

Local note for Oakville

Oakville's lakeside humidity and freeze-thaw winters are hard on automatic-gate electronics and sensors. Moisture in a control enclosure, a photo-eye fogged or knocked out of alignment by a snowbank, or a connector corroded by winter road salt will all stop an otherwise healthy gate. We seal, re-align and weatherproof as part of the repair, not just swap the part.

Click Here to Call (647) 930-4513 Now